2011 Ram 1500 Blend Door Actuator Location

The blend door actuator is the hardest to access, it is located at the bottom center of the dash directly above the center hump for the exhaust.

Is the box outline at the door supposed to line up with the keyed portion of the actuator post?

The heater treater videos do not show how to change the temperature control actuator and the recirc door actuator (there are 5 total actuators and 3 of them would take.

4th gen kits are now available!

Does anyone know the position that it should be in?

223k views 8 years ago.

When u buy the replacement part at the dealer, it comes with the.

This kit includes new solid aluminum hvac doors to replace the.

Buy oem heater cores & actuators.

It happens a lot and it is a very expensive fix if you take it to a mechanic.

Blend Door Actuator Location: Location of This Part Because

This kit includes new solid aluminum hvac doors to replace the.

Buy oem heater cores & actuators.

It happens a lot and it is a very expensive fix if you take it to a mechanic.

If you're unable to buy the oem actuators from your dealer, trw is the.

If you remove the 2 screws holding the actuators in place, you can remove them and work the short lever that actually moves the door inside the box, you can feel & hear the.

The doors themselves were bad about breaking where the hinge mates to the actuator, on the dr rams.

If the lever is down you freeze and up you get only heat.

A little research indicated that the problem was almost certainly the blend door lever not being moved by the servo motor.

I created this video with the youtube.

The mode door actuator is.

Are the marks on the.

How to replace a blend door actuator on a 2010 dodge ram 1500.